Metal Roofing Directly Over Plywood

Align the first metal roofing panel so that it overlaps the edging by 1 2 to 3 4 of an inch and is square to the roof line.

Metal roofing directly over plywood.

In this installation the vapor barrier is installed on the side of the insulation nearest the interior of the building. Be sure the larger edge is laid so that the small edge of the next panel will overlap it. A benefit to doing it this way is that you can see if there is any rotten plywood that needs to be replaced before installing the new roof. When using plywood nail it directly to the purlins and screw the metal roofing panels through the plywood into the purlins as instructed by the manufacturer.

I don t want the extra expense of the 1 x4 s if i. Can i install the metal roof over the ice shield or do i need the 1 x 4 battens every 2 feet as well it s a low slope roof thus the ice shield for extra protection. I have removed all the old shingles from the roof boards not plywood the roof is in great shape and have installed an ice shield over the roof. Energy efficient and available in a variety of colors that will add value to your home metal roofing is a wise choice for homeowners.

The plywood should be clean and free of raised nail heads to provide a uniform deck structure for the metal. Install waterproof felt over the plywood to add protection against moisture. I wonder if it is okay to fix the metal roof panels directly to the plywood roof deck with underlayment in between or do i need to attach the panels to 1 x4 lath. I just haven t found any good evidence that it would be a bad idea to use a metal roof over an unvented attic.

1 remove the shingles before installing the metal roof the first way to install a metal roof over shingles is by completely removing the old shingles before installing the new metal roof. There are two ways to do this put in firring nailing though nails are not used any more for this strips or purlins in steel frame construction on the roof to support it or place the metal roofing directly on a flat surface like foam insulation board or the roof sheathing with roof water barrier in the correct position in the layer. In reading online it seems wise to install a vapor barrier over the plywood to prevent condensation from getting adsorbed into the plywood from the steel roof. But it seems the condensation will affect the 2x4 strapping.

So i plan to do it.